I have a Dell All-in-One 810 printer from years ago and only recently installed it (a few months ago). Later I had reason to uninstall and re-install the printer but whenever I connect the printer Windows installs the printer drivers from its cache without the CD. Mar 06, 2012  I have a new HP Computer with windows 7 and I am trying to set my Dell 810 All in one Printer to it. I have installed the driver from the CD that I have but it will not print.

Ink Cartridge Maintenance • Turn on your printer. • Lift the printer unit, and position the scanner support between the tabs to hold it open. The ink cartridge carrier moves and stops at the loading position unless the printer is busy. • Press down on the ink cartridge lever to raise the ink cartridge lid. • Remove the old ink cartridge. Hp Compaq Dc7600 S.

Hp Bios Dv6000. • Dispose of the old cartridge properly. • If you are installing a new ink cartridge, remove the sticker and transparent tape from the back and bottom of the ink cartridge.

• Insert the new ink cartridge. • Snap the lid closed. • Lift the printer unit, and hold the scanner support up while lowering the printer unit until it is completely closed. Answered on Dec 02, 2015. When the paper goes it on the inside of the printer grabs both side which what feeds it through, if it is not tight enough will cause paper jams, open it back up and check the roller to see if it can be adjusted if it cant then you will need to buy a new one, this usualy happens when it has had too many paper jams forcing the gap to increase in size and not allow the collection of one but many, on single sheets of paper the gap wont be small enough to collect 1 sheet anymore. Answered on Jul 10, 2015. Open the printer cover with it turned on and connected to your pc.

When you open the cover, the printer should bring the ink cartridge carrier to the front and center so you can access cartridges easily. Press or pull the plastic tab next to the ink cartridge that you wish to replace and it will pop it up towards you and out of the carriage. If there is no plastic tab to eject the cartridge, grab a hold of it with your finger and pull upward and out towards you. Don't worry about breaking anything or harming the cartridge.

Once you remove the old one, remove the plastic tape tab on the new cartridge before inserting. Then close the printer cover and it should walk you through aligning the print heads on the display. Good luck! Answered on Oct 11, 2011. Hi Disconnect the unit completely from the AC outlet for 5 or 10 minutes, then plug it back again.It will works.